Detailed list of all the components needed for the NANO OLED type Open Annealer, including descriptions and specifications, to help you source everything required for your DIY project.

The first Open Annealer kit is based on a Nano micro processor (Arduino or clone, the UNO will of course work too) and a 1.3" OLED display. All components, ready to assemble, can be bought as a bundle from [COMING SOON]. You can choose to source the components

Remove the 12 screws holding the metal enclosure together to dismount the front and back plates. Keep the screws a safe place - you'll need them later. Locate the 3 brackets for mounting power supplys, controller board and solid state relay. Attach the microprocessor mount to the rear

IMPORTANT: If a power supply has a jumper switch on the side (sometimes hidden under a sticker), make sure it's set to correct voltage for your mains. Locate the 48V power supply and place it (slide it in) on the back side of the brackets as shown in

Now it's time to attach the controller board and the fan to 12V DC. Make sure the power is off and no connection to mains is made. Locate the fan and the power jack cable. Connect the stripped ends of the wires by twisting them. Black from power

Grab the OLED display and the 4 lead connector cable from the kit. Make sure the power is off and no connection to mains is made. Look at the front of the OLED display and locate the connectors for GND, VCC, SCL and SDA. Attach the brown wire to GND,

The rotary encoder/decoder is connected to the controller board using the 5 lead connection cable. Make sure the power is off and no connection to mains is made. Connect one end of the cable to the encoder/decoder as shown in the picture below. Brown connects to GND, Red

Find the vibration sensor and the 3 wire connector cable (with the colors red, brown and orange) in the kit. Make sure the power is off and no connection to mains is made. Attach orange wire to DO, brown wire to GND and red wire to VCC as shown in

Find the servo motor in the kit. Make sure the power is off and no connection to mains is made. The servo motor is easily connected to the controller board at position D9. Yellow goes to S (blue pin), red goes to V (red pin) and brown goes to G

Find the solid state relay and the 2 thick red wires (stripped in both ends). Attach the 2 wires securely to the output side of the SSR. Find the 2 signal/input wires for the SSR. One black and one red - both are stripped in one end and have

Find the feeder signal cables in the kit. Attach the red wire to the the blue pin for D12 (S). Attach the black wire to the black pin (G). Attach the red wire connected to the input side of the SSR to the blue pin for D13 (S). Attach the

It's time to fix the loose ends. First we'll connect the thick red wire going out from + on the output side of the SSR to one of the + terminals on the 48V power supply. Twist the leads before attaching to ensure good connection. Caution: As mentioned

Place the brackets with all the components attached on the lower part of the enclosure. Adjust placement of the 48V power supply by sliding it forth and back until enough clearance has been achieved to mount the front and rear of the enclosure. Fasten the rear end of the enclosure